Customer Name: Southern Light, LLC - AT&T Clec Online

Page 253 of 374
ATT 4 – COLLOCATION/AT&T-9STATE
PAGE 14 OF 44
Southern Light
1Q08 GENERIC INTERCONNECTION AGREEMENT – 03/10/08
Collocation Space is located. In Florida, Southern Light must have approval by the Commission
before it submits a request for copper entrance facilities. Notwithstanding the foregoing, in the
case of adjacent collocation, copper facilities may be used between the adjacent collocation
arrangement and the central office demarcation point, unless AT&T determines that limited space
is available for the placement of these entrance facilities.
5.7 Dual Entrance Facilities at a Central Office. AT&T will provide at least two (2) interconnection
points at each Central Office where at least two (2) such interconnection points are available and
capacity exists. Upon receipt of a request by Southern Light for dual entrance facilities to its
physical Collocation Space, AT&T shall provide Southern Light with information regarding AT&T’s
capacity to accommodate the requested dual entrance facilities. If conduit in the serving
manhole(s) is available and is not reserved for another purpose or for utilization within twelve (12)
months of the receipt of an application for collocation, AT&T will make the requested conduit space
available for the installation of a second entrance facility to Southern Light’s Collocation Space.
The location of the serving manhole(s) will be determined at the sole discretion of AT&T. Where
dual entrance facilities are not available due to a lack of capacity, AT&T will provide this
information to Southern Light in the Application Response.
5.8 Shared Use
5.8.1 Southern Light may utilize spare capacity on an existing telecommunications carrier’s entrance
facility for the purpose of obtaining an entrance facility to Southern Light’s Collocation Space within
the same AT&T Premises.
5.8.2 AT&T shall allow the splice, as long as the fiber is non-working dark fiber. Southern Light must
arrange with AT&T in accordance with AT&T’s Special Construction Procedures, RL93-11-030BT,
and provide a LOA from the other telecommunications carrier authorizing AT&T to perform the
splice of the Southern Light-provided riser cable to the spare capacity on the other
telecommunications carrier’s entrance facility. If Southern Light desires to allow another
telecommunications carrier to use its entrance facilities, the telecommunications carrier must
arrange with AT&T in accordance with AT&T’s Special Construction Procedures, RL93-11-030BT,
and provide a LOA from Southern Light authorizing AT&T to perform the splice of the
telecommunications carrier’s provided riser cable to the spare capacity on Southern Light’s
entrance facility.
5.9 Demarcation Point
5.9.1 In Tennessee, if Southern Light elects the Tennessee Regulatory Authority (TRA) rates as set forth
in Exhibit C, the additional language also set forth in Exhibit C for Demarcation Point, will be
effective in conjunction with the remaining terms and conditions of this Attachment.
5.9.2 AT&T will designate the point(s) of demarcation between Southern Light’s equipment and/or
network facilities and AT&T’s network facilities. For 2-wire and 4-wire connections, the
demarcation point shall be a common block on the AT&T designated conventional distribution
frame. Southern Light shall be responsible for providing the common block and cabling and
Southern Light’s AT&T Certified Supplier shall be responsible for installing and properly
labeling/stenciling the common block and any necessary cabling identified in Section 7 below. For
DS1, DS3, STS1, and optical terminations, AT&T shall designate, provide, and install demarcation
point hardware on a per arrangement basis. Southern Light shall be responsible for providing, and
Southern Light’s AT&T Certified Supplier shall be responsible for installing any necessary cabling
and properly labeling/stenciling the demarcation point hardware for terminations identified in
Section 7 below.
CCCS 253 of 370