Sym Jet Euro X servicemanual - Scootergrisen
Sym Jet Euro X servicemanual - Scootergrisen
Sym Jet Euro X servicemanual - Scootergrisen
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
7. “V” TYPE BELT DRIVE SYSTEM/KICK-STARTER<br />
Clutch/Driven Pulley<br />
Disassembly<br />
Remove drive belt and clutch/driven pulley.<br />
Install clutch spring compressor onto the pulley<br />
assembly, and operate the compressor to let nut<br />
be installed more easily.<br />
7-10<br />
Caution<br />
Do not press the compressor too much.<br />
Hold the clutch spring compressor onto bench<br />
vise, and then remove mounting nut with clutch<br />
nut wrench.<br />
Release the clutch spring compressor and<br />
remove clutch and spring from driven pulley.<br />
Remove socket from sliding pulley.<br />
Remove guide pin, guide pin roller, and driven<br />
pulley, and then remove O-ring & oil seal seat<br />
from sliding pulley.<br />
Inspection<br />
Clutch outer<br />
Measure the inner diameter of clutch outer<br />
friction face. Replace clutch outer if exceed<br />
service limit.<br />
Service limit: 107.5 mm<br />
This chapter Contents<br />
Sliding pulley<br />
O-ring<br />
Inner<br />
diameter<br />
Oil seal<br />
Clutch nut<br />
wrench<br />
Clutch spring<br />
compressor<br />
Guide pin<br />
or<br />
Clutch outer<br />
Socket<br />
Guide pin roller