Sym Jet Euro X servicemanual - Scootergrisen

Crankcase Disassembly
Remove the crankcase bolts.
Install the crankcase puller onto the right
crankcase with two (2) bolts, 6mm, as the
diagram shown.
Disassemble the right crankcase.
Crankshaft Removal
As the diagram show with 3 special bolts to
install the specified service tool onto the left
crankcase.
Remove the crankcase.
Caution
Do not use iron hammer to knock out the
crankshaft.
Remove crankshaft bearing with bearing puller.
Remove the right and left side oil seals.
Caution
Replace the oil seal with new one as
removing the crankshaft.
This chapter Contents
9. CRANKCASE/CRANKSHAFT
Right crankcase
Shaft protection collar
Bolts
Crankcase puller
Crankcase puller
Left crankcase
Outer bearing puller
9-3