Manual tehnic automate cafea Saeco Group 500

- Make sure there are no lumps; do not
compress the product nor use an excessive
quantity as to avoid ageing of the product
itself. We suggest filling the containers with
the quantity of product needed for the
consumption estimated within two
subsequent loadings.
Refer to the TECHNICAL SPECIFICATIONS
section to check each container capacity.
fig.32
Warning
- Before using the machine, to ensure the
proper operation of the container with
orientable duct, perform 3 - 4 brewings to fill
the channel.
- Once the sugar container is filled, make sure
the panel is properly reassembled, by
checking the click located on one side.
6.8.2 Label insertion
- The labels indicating the product selections
shall be inserted in the special slots according
to the order shown in figure 42.
Perform the operation as follows:
- remove the cup column (fig. 32)
- insert labels following to the order shown and
according to the selections used by the
machine (fig.33)
- reassemble the cup column
fig.33
6.8.3 Cup loading
fig.34
English
Use only cups conceived for automatic vending
machines, with a diameter of 70-71 mm, do not
compress the cups together while loading.
Important: DO NOT TRY TO ROTATE
THE CUP COLUMN MANUALLY.
During installation phase with the cup dispenser
completely empty, operate as follows:
- before powering the vending machine, load a
column of cups, as long as it is not the one
relevant to the dispensing ring (fig.34)
23