EN: man_8055tco_user.pdf - Fagor Automation

6. This window shows the status of the «G, F, T, D, M» functions and the value of
the variables.
PARTC It indicates the number of consecutive parts executed with the
same part-program.
Every time a new program is selected, this variable is reset to "0".
CYTIME Indicates the time elapsed while executing the part. It is given in
"hours : minutes : seconds : hundredths of a second".
Every time a part-program execution starts, even when repetitive,
this variable is reset to "0".
TIMER Indicates the count of the timer enabled by PLC. It is given in "hours
: minutes : seconds".
7. Reserved.
8. Reserved.
Selecting a program for simulation or execution
Symbol that appears in the middle of the top window when a part-program has been
selected for simulation or execution.
15:28:42
X
Z
S
00044.000
HOME X 0023.700
-00443.331
HOME Z -0009.578
0
U 00025.000
B 00000.013
C 00014.480
F 0100.000 % 080
P000002 15:28:42
T 02
D 12
CHANGE POSITION
X 25.000 Z 85.000
S 0100
% 115
SMAX 1000
RANGE 1
M0
(MSG " " )
(IF P102 EQ 1 GOTO N10)
(IF P101 EQ 0 RET)
M3
(RET)
N10 M4
(RET)
COMMAND ACTUAL
X 00020.000
Z 00089.520
C 00014.480
THEORETICAL
P000002
G01 G18
M41
PARTC : 000000
CYTIME : 00:00:00:00
TIMER: : 000000:00:00
TO GO FOLLOWING ERROR
X 00020.000 X 00000.000 X 00000.000
Z 00089.520 Z 00000.000 Z 00000.000
C 00014.480 C 00000.000 C 00000.000
RPM M/MIN
S 0.0000 S 0.0000 S 0.0000 S 0.0000
U 00025.000 B 00000.013
When the top center window shows the part-program selected next to the green
[START] symbol, the CNC acts as follows:
If [START] is pressed, the CNC executes the part-program that is selected.
If [CLEAR] is pressed, the CNC de-selects the part-program and removes it from
the top center window.
Operating manual
OPERATING IN JOG MODE
Introduction 2.
·MCO/TCO·
Option
Soft: V01.0x
·15·