EN: man_8055tco_user.pdf - Fagor Automation

4.4 Delete a new part program
To delete a part-program, proceed as follows:
Press [P.PROG] to access the list of part-programs stored.
Select, with the pointer, the part-program to be deleted from the left column.
Press [CLEAR].
The bottom of the screen will show a message requesting confirmation of the
deleting operation.
If [ENTER] is pressed, the CNC will delete the selected program and will update
the list of saved programs.
If [ESC] is pressed, the program will not be deleted and it will quit deleting
operation.
4.5 Copying a part-program into another one
To copy a part-program into another one, proceed as follows:
Press [P.PROG] to access the list of part-programs stored.
Select, with the pointer, the part-program to be copied from the left column.
Press the [P.PROG] key.
The bottom of the screen will show a message requesting the number to be
assigned to the copy.
Enter the number of the desired program and press [ENTER].
It must be a number between 1 and 899999, both included.
If there is already a part-program with that number, the bottom of the screen will
show a message asking to either replace it or cancel the operation?
If [ENTER] is pressed, the CNC will request a new program number.
If [ESC] is pressed, the CNC will not delete the current program and will copy the
program.
The CNC requests the comment to be associated with the new part-program (the
copy).
It is not necessary to associate a comment.
Press the [ENTER] or [ESC].
The CNC updates the list of saved part-programs.
Operating manual
SAVING PROGRAMS
Delete a new part program 4.
·MCO/TCO·
Option
Soft: V01.0x
·55·