EN: man_8055tco_user.pdf - Fagor Automation

Graphic parameters:
Simulation speed:
Select on the top right side of the screen the percentage of simulation
speed to be applied.
Use the [][] keys to select the percentage and press [ENTER] for the
CNC to assume that value.
Tool path colors:
It only makes sense in line graphics (not in solid ones). It lets you choose
the colors to represent rapid traverse, the tool path without compensation
and the tool path with compensation.
Use the [] [] keys to select, on the right side of the screen, the type of
path and use the [] [] keys to select the color to be applied.
Press [ENTER] for the CNC to assume those values.
Colors of the solid graphics:
It only makes sense in solid graphics (not in line graphics). It lets you use
the colors to represent the cutter, the part, the axes and the clamps.
Use the [] [] keys to select, on the right side of the screen, the type of
path and use the [] [] keys to select the color to be applied.
Press [ENTER] for the CNC to assume those values.
Clear screen:
When selecting this option, the CNC clears the screen and shows the axes or the
part unmachined.
The screen cannot be cleared while executing or simulating the part. If it is,
interrupt the simulation by pressing the [STOP] key.
Once the type of graphics, the display area, the graphic parameters, etc have been
selected, press the [START] key to start graphic simulation.
During graphic simulation, the CNC takes into account the simulation speed and the
position of the right feedrate override switch (0%-120% FEED).
When selecting a new simulation speed, the CNC applies 100% of it regardless
of the position of the switch.
Once the switch is turned, the CNC begins to apply the selected %.
To interrupt the simulation, press [STOP].
To quit the simulation mode, press either [GRAPHICS] or [ESC].
Operating manual
EXECUTION AND SIMULATION
Graphic representation 5.
·MCO/TCO·
Option
Soft: V01.0x
·65·