EN: man_8055tco_user.pdf - Fagor Automation

Operating manual
5.
EXECUTION AND SIMULATION
Execution mode
·MCO/TCO·
Option
Soft: V01.0x
·62·
5.4 Execution mode
When pressing [START] to execute an operation or part-program, the CNC shows
the standard screen of the CO mode.
15:28:42 SBK P000002 IN POSITION
X
Z
S
00044.000
HOME X 0023.700
-00443.331
HOME Z -0009.578
0
U 00025.000
B 00000.013
C 00014.480
F 0100.000 % 080
T 02
D 12
CHANGE POSITION
X 25.000 Z 85.000
S 0100
% 115
SMAX 1000
RANGE 1
TCO model MCO model
When pressing the [TWO-COLOR] key, the CNC shows the special screen of the CO
mode.
15:28:42 P000002
M0
(MSG " " )
(IF P102 EQ 1 GOTO N10)
(IF P101 EQ 0 RET)
M3
(RET)
N10 M4
(RET)
COMMAND
X 00020.000
Z 00089.520
THEORETICAL
ACTUAL
X 00020.000
Z 00089.520
Once the operation or part has been selected, it may be executed as often as desired;
to do that, once the execution has finished, pressed the [START] again.
While executing an operation or a part, the [GRAPHICS] key may be pressed to
access the graphics display mode.
To interrupt the execution, press [STOP].
15:28:42 SBK P000002 IN POSITION
Once the execution has been interrupted, a tool change may be done. See next
section.
X
Z
S
00044.000
HOME X 0000.000
-00443.331
-00443.331
Y HOME Y 0000.000
HOME Z 0000.000
115
U 00025.000
B 00000.013
C 00014.480
F00100.000 % 080
TO GO
RPM M/MIN
G01 G18
M41
PARTC : 000000
CYTIME : 00:00:00:00
TIMER: : 000000:00:00
X 00000.000
Z 00000.000
FOLLOWING ERROR
X 00000.000
Z 00000.000
S 0.0000 S 0.0000 S 0.0000 S 0.0000
T 02
D 12
CHANGE POSITION
X 25.000
Y 35.000
Z 85.000
S 00100
% 115
RANGE 1