PT-F100U
PT-F100U
PT-F100U
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Preparation<br />
Read this first<br />
Minimum required setting screen<br />
When you start the projection for the first time, the minimum required setting screen for projection will be displayed.<br />
LANGUAGE<br />
Select the required language setting.<br />
LANGUAGE<br />
Press F G I H buttons of the Remote control or<br />
Control panel on the projector to highlight the<br />
required language, and press ENTER to proceed to<br />
the next setting.<br />
O<strong>PT</strong>IONS<br />
Select the current projection method and fan speed<br />
setting. If you need return to the previous setting,<br />
press the RETURTN button.<br />
O<strong>PT</strong>ION<br />
ENGLISH - 12<br />
SELECT<br />
INSTALLATION<br />
ENTER<br />
FRONT/DESK<br />
HIGHLAND OFF<br />
SELECT<br />
RETURN<br />
ENTER<br />
INSTALLATION<br />
Press I H buttons of the Remote control or<br />
Control panel on the projector to select the<br />
required installation method. Press G to proceed to<br />
the HIGHLAND setting.<br />
FRONT/DESK<br />
FRONT/CEILING<br />
REAR/DESK<br />
REAR/CEILING<br />
Setting on a desk/floor and<br />
projecting from front<br />
Mounting in the ceiling and<br />
projecting from front<br />
Setting on a desk/floor and<br />
projecting from rear<br />
Mounting in the ceiling and<br />
projecting from rear<br />
HIGHLAND<br />
If you use the projector at high elevation, the<br />
HIGHLAND setting need to be ON to set the fan<br />
speed high. Press I H to select the required<br />
option. If you need to return to the INSTALLATION,<br />
press F.<br />
OFF The fan speed is low.<br />
ON The fan speed is high.<br />
NOTE:<br />
• At 1 400 m (4 593 ft) above sea level, the setting must<br />
be ON.<br />
• The loudness of fan noise depends on the HIGHLAND<br />
setting.<br />
Press the ENTER button to start the projection.<br />
Once you finish the minimum requirement setting, it will not be displayed again unless the projector is<br />
initialised. See “INITIALIZE ALL” on page 38.<br />
You can change the settings from the MAIN MENU. See “Menu Navigation” on page 29.