PT-F100U
PT-F100U
PT-F100U
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
REMOTE terminal<br />
Technical Information<br />
You can remotely operate the projector from the outside the Remote control range by connecting to the REMOTE<br />
terminal.<br />
Pin assignments and signal names<br />
LAMP switching<br />
Switching input signals<br />
Pin No. Signal name Contents<br />
A GND Ground<br />
B POWER POWER ON<br />
C INPUT SEL3 Select input signal 3<br />
D NC<br />
E INPUT SEL1 Select input signal 1<br />
F INPUT SEL2 Select input signal 2<br />
G<br />
Connect internally<br />
H<br />
I ENABLE Control by external contact<br />
Pin No. Settings<br />
B - A Short Open<br />
Operation On Off<br />
Pin No. Settings<br />
C - A Open Open Short Short Short Open<br />
E - A Open Short Open Open Short Short<br />
F - A Open Open Short Open Open Short<br />
Input signal COMPUTER1 COMPUTER2 COMPONENT VIDEO S-VIDEO NETWORK<br />
NOTE:<br />
• When pin A and pin I are short-circuited, the buttons on the projector’s control panel, POWER and INPUT SELECT<br />
buttons on the Remote control cannot be used. In addition, the RS-232C commands and network functions that<br />
correspond to these functions cannot be used either.<br />
• While pin I is “Open”, do not short-circuit pin A, B, C, E and F. The projector would reject all the signals from the<br />
Remote control.<br />
ENGLISH - 49<br />
Appendix