PT-F100U

Remote control operation
Operating range
Setting up the image position automatically
You can adjust the setting of SIGNAL
SEARCH, DOT CLOCK and CLOCK PHASE
automatically for the projected COMPUTER
signal image.
NOTE:
• SIGNAL SEARCH will be adjusted only when the
SIGNAL SEARCH is set to ON.
• If the dot clock frequency is 108 MHz or higher, AUTO
SETUP is not effective.
• If the projected image is dark or blurred around the
edge, AUTO SETUP may stop the processing before
complete. Project a much clearer or lighter image and
press the AUTO SETUP button again.
You can operate the projector with the Remote control
within the remote range 15 m (49'2").
Facing to the projector
Ensure the Remote control emitter is facing to
the Remote control signal receptor on front/back
of the projector and press the required buttons to
operate.
Facing to the screen
Ensure the Remote control emitter is facing to
the screen and press the required buttons to
operate the projector. The signal will be reflected
off the screen. The operating range may differ due
to the screen material.
NOTE:
• Do not let strong light shine onto the signal receptor.
The Remote control may malfunction under strong
light such as fluorescent.
• If there are any obstacles between the Remote control
and the Remote control signal receptor, the Remote
control may not operate correctly.
Screen Projected image
ENGLISH - 25
Basic Operation