PT-F100U

Appendix
Technical Information
Cable specifications
(When connected to a personal computer)
Control commands
Command Control contents Remarks
PON Power ON
POF Power OFF
AVL Volume
You can switch the signals which to output from the COMPUTER1 OUT terminal by pressing the computer key
command. The key commands are depend on the manufactures. If you select the computer terminals which has no
signals while the INPUT GUIDE is set to DETAILED, the computer connection guidance will be displayed.
ENGLISH - 48
IIS INPUT
Q$S
Lamp condition
query
OSH SHUTTER
In standby mode, all commands other than the PON command are
ignored.
The PON command is ignored during lamp ON control.
If a PON command is received while the cooling fan is operating after the
lamp has switched off, the lamp is not turned back on again straight away
in order to protect the lamp.
Parameter
000 - 063 (Adjustment value 0 - 63)
Parameter:
VID = VIDEO IN
RG1 = COMPUTER1
NWP = WIRELESS (PT-F100NTU only)
Call back
0 = Standby
1 = Lamp ON control active
Computer connection guidance
SVD = S-VIDEO IN
RG2 = COMPUTER2
2 = Lamp ON
3 = Lamp OFF control active
Turning off the projection temporarily.
Send the command to switch between ON and OFF.
Do not send the command consecutively.
Manufacturer Key command Manufacturer Key command Manufacturer Key command
Panasonic
NEC
FUJITSU +
+
NC
NC
Projector PC (DTE)
NC
NC
TOSHIBA
SHARP
HP
EPSON
DELL
+
IBM
SONY
Apple
+ Other +
NOTE:
• The computer connection guidance will disappear after 5 minutes.
• Please refer the instructions which provided with the computers for more detailed information.
NC
NC
NC
NC
+