X515C DF & X510C Manual - Lowrance

To view the Alarm Status window, highlight the Alarm Status tab and
press ENT.
To set NMEA 2000 Alarm:
1. Press MENU|MENU, select NMEA 2000 and press ENT.
2. Highlight NMEA 2000 ALARMS and press ENT.
3. Highlight FLUID LEVEL DEVICE and press ENT. Use ↑ ↓ to select the device
you want to set an alarm for and press ENT.
4. Highlight the ENABLED box next to the desired alarm (Full Alarm or
Empty Alarm) and press ENT to turn on the alarm.
5. To set the alarm percentage, press → to highlight PERCENT and press
ENT.
6. Use ↑ ↓, ← → to input the desired percentage and press ENT. Repeat
Steps 3-4 to set the other alarm.
7. Highlight SET CONFIGURATION and press ENT to finalize alarm settings.
Press EXIT repeatedly to get back to the main display.
NOTE:
To turn off (uncheck) an alarm, highlight its ENABLED BOX and press
ENTER.
Waypoint Sharing
Waypoint Sharing allows you to share a waypoint from one display unit
with display units across the network.
To turn on/off Waypoint Sharing:
1. Press MENU|MENU, select NMEA 2000 and press ENT.
2. Highlight WAYPOINT SHARING and press ENT which will turn on/off waypoint
sharing.
3. Press EXIT repeatedly to get return to the main display.
Backlight Synchronization
The Backlight Synchronization command will keep all display unit
backlight levels consistent across the NMEA 2000 network. So, if you
set the backlight level to 75% on one display unit, all other units on the
network will automatically switch to the same setting.
To turn on/off Backlight Synchronization:
1. Press MENU|MENU, select NMEA 2000 and press ENT.
2. Highlight BACKLIGHT SYNCHRONIZATION and press ENT, which will turn
on/off Backlight Synchronization.
3. Press EXIT repeatedly to get back to the main display.
96