X515C DF & X510C Manual - Lowrance
X515C DF & X510C Manual - Lowrance
X515C DF & X510C Manual - Lowrance
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
72.9<br />
[2.87]<br />
173.9<br />
[6.85]<br />
23.4<br />
[0.92]<br />
137.9<br />
[5.43]<br />
157.9<br />
[6.22]<br />
Millimeter<br />
[Inch]<br />
56.9<br />
[2.24]<br />
Front view (left) and side view (right) showing dimensions of the<br />
sonar unit when mounted on gimbal bracket.<br />
After drilling the hole, pass the transducer connector up through the<br />
hole from under the dash. Pass the power cable's bare-wire end down<br />
though the hole from the top.<br />
If you wish, you can fill in the hole around the cables with a good marine<br />
caulking compound. (Some marine dealers stock cable hole covers<br />
to conceal the opening.) No matter what type of installation you prefer,<br />
be sure to leave enough slack in the cables to allow tilting or swiveling<br />
the unit. If you choose to fill in the hole, be sure to position the cables<br />
against the rear edge of the hole as you apply the fill material.<br />
Before positioning the bracket, be sure to hold the cables against the<br />
rear edge of the hole. Then, slide the bracket over the hole and butt the<br />
rear of the bracket base firmly against the cables, thus pinning them in<br />
place against the side of the hole. Finally, fasten the bracket to the<br />
dash. Attach the unit to the gimbal bracket using the supplied gimbal<br />
knobs and washers.<br />
In-Dash Installation<br />
You can mount the unit in the dash with an optional FM-5 In-Dash<br />
Adapter Kit. The kit includes mounting hardware, a template for cutting<br />
the hole and an instruction sheet, part 988-0147-43.<br />
31