X515C DF & X510C Manual - Lowrance
X515C DF & X510C Manual - Lowrance
X515C DF & X510C Manual - Lowrance
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
3. Select the EP-15 Fluid Level and press ENT.<br />
4. Press ↓ to select CALIBRATE and press ENT. The Device Calibration<br />
menu will appear. Instructions on Calibration will be listed at the top<br />
of the menu.<br />
5. Highlight NUM PTS, press ENT and select 2. Press ENT.<br />
6. Select FLUID LEVEL, press ENT, then select EMPTY LEVEL and press ENT.<br />
7. Make sure the fuel tank is empty, highlight CALIBRATE and press ENT.<br />
The following message will appear: Empty Level Calibration Completed.<br />
Press ENT.<br />
8. Fill up your tank, highlight FLUID LEVEL and press ENT.<br />
9. Select FULL LEVEL and press ENT. Highlight CALIBRATE and press ENT.<br />
10. The following message will appear: Full level Calibration Completed.<br />
Press ENT, then press EXIT repeatedly to get back to the main<br />
display.<br />
Calibrate is highlighted on the device configuration menu (left). Calibration<br />
menu (right) with calibration instructions listed at the top.<br />
3-Point Calibration<br />
3-point calibration is designed for tanks that vary in shape from the top<br />
to the bottom. You can begin calibration at any point in the 3-point<br />
process, but we recommend starting calibration with an empty tank.<br />
In a 3-point calibration, you will set three points, one each for empty,<br />
half and full levels.<br />
1. Press MENU| MENU, use ↓ ↑ to select NMEA 2000 and press ENT.<br />
2. Highlight BUS SETUP and press ENT, which will open the Bus Configuration<br />
menu. A list of network devices will be at the top of the page. 3.<br />
Select the EP-15 Fluid Level and press ENT.<br />
107