View - ADTRAN Support Community

Configuration Command Summary
Table 10. Deleting a Community
Step 1
Command
(config)#ip prefix-list seq
[deny | permit]
[ge | le]
Description
Creates a prefix list to define the routes
from which a community is to be deleted.
Range is 1 to 4294967294.
Step 2 (config)#ip community-list Creates a community list for a BGP route
map use. The communities defined in
this list will be deleted.
Step 3
Step 4
Step 5
Step 6
Step 7
(config-comm-list)#permit [ | internet |
local-as | no-advertise | no-export]
(config-comm-list)#exit
(config)#route-map [deny | permit]
(config-route-map)#match ip address
prefix-list
(config-route-map)#set comm-list
delete
Adds an entry to the community list that
defines the community string in the
community attribute that should be
deleted.
Exits the Community List Configuration
mode.
If one does not already exist, creates a
route map. Range is 1 to 4294967295.
Specifies the routes from which a
community is to be deleted. Reference
the of the prefix list created in
Step 1 to add it to the route map entry.
Specifies a list of communities to delete.
Reference the of the community
list created in Step 2.
Step 8 (config-route-map)#exit Exits Route Map Configuration mode.
Step 9 (config)#router bgp Enters BGP Configuration mode. Range
is 1 to 4294967295.
Step 10 (config-bgp)#neighbor Enters BGP Neighbor Configuration
mode for the neighbor to which the route
map is to be applied.
Step 11
(config-bgp-neighbor)#send-community
standard
Enables this AOS device to accept a
community attribute or add a community
attribute to any advertisement sent by
this peer.
Step 12 (config-bgp-neighbor)#route-map in Applies the route map to the BGP
neighbor as an inbound policy.
Step 13 (config-bgp-neighbor)#do write Saves the configuration.
Refer to Prefix List on page 21 for more information on creating prefix lists. Refer to
Deleting Communities from a Route on page 15 for more information on the set comm-list
delete command.
61200860L1-29.4E Copyright © 2012 ADTRAN, Inc. 65