Operations Manual - PRO-111FD - Pioneer
Operations Manual - PRO-111FD - Pioneer
Operations Manual - PRO-111FD - Pioneer
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Install Your Flat Panel TV<br />
02<br />
2.1.1 Check the Location for Suitability<br />
When choosing the location for your panel, there are several factors you need to keep in mind. The installation<br />
site should be out of direct sunlight and have sufficient ventilation around the flat panel TV to allow cooling. The<br />
diagram below is an example of a stand-mounted panel with proper ventilation.<br />
Over 50 cm<br />
(19 11/16 inches)<br />
Over<br />
10 cm<br />
(3 15/16<br />
inches)<br />
The distance behind and above the panel<br />
changes depending on your choice of mount.<br />
Consult with your dealer or professional<br />
installer for proper ventilation.<br />
Use the checklist below to judge possible installation sites.<br />
Sufficient ventilation<br />
Safe from excessive vibrations<br />
Away from air conditioners<br />
Free of moisture or dampness<br />
No danger of splashing water<br />
Route cords and cables safely<br />
No danger of power overloads<br />
Separate from other IR equipment<br />
Protected from hits or shocks<br />
Distance from heat sources<br />
Out of direct sunlight<br />
Away from strong lighting sources<br />
For specific cautions and safety information, refer to “7.2 Physical Location & Temperature Considerations” and<br />
“7.7 Safety Precautions.”<br />
2.1.2 Lift and/or Move Your Panel (the How To’s)<br />
This flat panel TV is built for endurance but because of the technology, the panel must be handled with care. Use<br />
the handles attached to the rear of the flat panel TV to lift the unit. To avoid flexing or twisting the unit, you need<br />
at least two people to lift and move the panel. Do not move the flat panel TV by holding only a single handle or by<br />
dragging the panel by its handles.<br />
Use the handles to move the panel.<br />
Do not move the panel by holding the<br />
color sensor, speaker or speaker<br />
brackets.<br />
Note: Do not use the handles to hang the flat panel TV or as anchors to prevent the panel from slipping or tipping<br />
after it is mounted.<br />
15<br />
En