QT-400-4N Manual

More documents

Recommendations

Info

Alarm output There are three alarm output pin, the status of these pin are illustrated as below Before alarm N. O. COM N. C. After alarm There is an example for alarm output connection N. O. COM N. C. N. O. COM N. C. Alarm 5V 4.Hard Disk Connection There are several steps to install the hard disk. Note: If the DVR comes with a HDD, skip the following steps. 29
1. Pull out the hard drive rack from the DVR side panel. 2. Open the top cover of the drawer. 3. Jump HDD to Master 4. Connect the ribbon cable (IDE) cable & power cable. Jump to Master 5. Close the top cover of the drawer and put the hard drive drawer back into the DVR. (Make sure the cables are firmly pressed onto the HDD interface) 6. Lock the hard drive draw by turning the key clockwise. If you have another HDD, please jump that HDD to SLAVE, and open the machine, put the HDD to the HDD shelf, and then connect the power and digit cable. User Guideline 1.Start the Machine Before starting the machine, please make sure all the items in the “Security Notice” at the beginning of this manual are fulfilled. Before starting the machine, please check the system connection, input and output equipment connection. Please insure the video-recorder’s input video (NTSC/PAL) and the monitor (NTSC/PAL) meet the demands. 30
Page 1 and 2: Quaddrix - QT-400-4N 4-channel Digi
Page 3 and 4: • Support zoom, auto, and PIP fun
Page 5 and 6: 6.PLAYBACK ........................
Page 7 and 8: To change the password, please refe
Page 9 and 10: MENU LANGUAGE: Use “+” or “-
Page 11 and 12: 6. Auto Sequence Set When the curso
Page 13 and 14: Each channel’s name is the combin
Page 15 and 16: Network STATE: network SPEED switch
Page 17 and 18: 15. Motion Detection settings 1) Wh
Page 19 and 20: USBBACKUP SAVE: There are two types
Page 21 and 22: Buttons On the Front Panel The fron
Page 23 and 24: 2.PIP/2: PIP key, push this button,
Page 25 and 26: Display Statuses While Running 1.Sc
Page 27 and 28: System Connection 1.Back Panel and
Page 29: 3.Alarm Connection The DVR can supp
Page 33 and 34: 4.Alarm Recording Alarm recording i
Page 35 and 36: 7.Search Play Push search button,se
Page 37 and 38: Press menu button back to Search Pl
Page 39 and 40: 12.PIP Operation Push PIP button, t
Page 41: USB device from the moment, press U
Page 44 and 45: Setting Protocol PTC1 PTC1/ PTC2/ P
Page 46 and 47: Main standard & parameter chart Ite
Page 48 and 49: Appendix A: Trouble shooting guide
Page 50 and 51: A. Push display button to see if th
Page 52 and 53: Byte2 0xaa DVR identifier word Byte
Page 54 and 55: Appendix C: record time in for 120G
Page 56 and 57: ADSL Modem ISP Internet Ro u te r S
Page 59: As ADSL and CABLE MODEM network use

QT-400-4N Manual

Create successful ePaper yourself

Delete template?

Save as template?