Owner's Manual SSP-600 Surround Processor - Classé Audio
Owner's Manual SSP-600 Surround Processor - Classé Audio
Owner's Manual SSP-600 Surround Processor - Classé Audio
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
1 Composite Video Inputs<br />
The <strong>SSP</strong>-<strong>600</strong> supports up to four composite video input signals. These<br />
connections are labeled COMPOSITE INPUT 1, 2, 3, and 4. All these<br />
inputs are converted to both S-video and Component video as needed for<br />
viewing on the MAIN output.<br />
Connect the composite video output of your source component to the<br />
appropriate composite video input of the <strong>SSP</strong>-<strong>600</strong> using high quality 75Ω<br />
video cable for the best results. Your Classé dealer can assist you in making<br />
an appropriate cable selection.<br />
Note that the three analog video standards offer varying degrees of<br />
performance:<br />
• Component video offers the highest picture quality<br />
• S-Video is second-highest in picture quality<br />
• Composite video offers the lowest picture quality<br />
For this reason, you are advised to use component video connections<br />
whenever possible, and S-video connections when component is not<br />
available. Composite video connections should be used when the other<br />
options are not available, or on less critical sources (e.g., a VHS video<br />
cassette recorder, or perhaps a video game).<br />
2 Balanced Analog <strong>Audio</strong> Input<br />
Connect the right-channel and left-channel balanced outputs of your<br />
source components to the corresponding balanced inputs on the <strong>SSP</strong>-<strong>600</strong>.<br />
The pin assignments of these XLR-type female input connectors are:<br />
Pin 1: Signal ground<br />
Pin 2: Signal + (non-inverting)<br />
Pin 3: Signal – (inverting)<br />
Connector ground lug: chassis ground<br />
These pin assignments are consistent with the standards adopted by<br />
the <strong>Audio</strong> Engineering Society. Refer to the operating manuals of your<br />
balanced-output line-level sources to verify that the pin assignments of<br />
their output connectors correspond to the <strong>SSP</strong>-<strong>600</strong>. (This is not necessary<br />
if the source component in question is also made by Classé.) If not, wire<br />
the cables so that the appropriate output pin connects to the equivalent<br />
input pin.<br />
Please note that while using the balanced analog bypass mode, all singleended<br />
main outputs are muted.<br />
23