User Manual - TRS-RenTelco

Setting Up Measurements
There are three ways set up the VM5000 to take measurements: taking measurements,
taking measurements relative to a reference, and taking measurements
with limit testing. The differences between the three ways of taking measurements
are:
Taking measurements displays only the results of the measurements.
Taking measurements relative to a reference displays the results of the
measurements taken and the difference between the measured value and a
reference value.
Taking measurements with limit testing displays the results of the measurements
taken and a Pass/Fail indication of whether the taken measurement
falls within (pass) or outside (fail) specified maximum and minimum values.
You can choose to take measurements relative to a reference and with limit
testing concurrently.
Taking Measurements
The procedure for taking measurements is:
1. Option SD/HD: Select the appropriate format and the color space for the
input signal.
or
Option VGA: Select the appropriate resolution, the refresh rate and the
timing standard for the input signal.
2. Select one or more measurements to take.
3. Select Configuration > Operations.
4. Set the Setup And/Or Run, Run Mode, and Auto Scaling setting for
controlling the operation.
5. Select the Run button to take and view the measurements.
6. Views the measurement results by selecting the corresponding menu item in
the results panel of the measurement.
VM5000 Automatic Video Measurement Set User Manual 3-59