User Manual - TRS-RenTelco

Setting Up Measurements
There are three ways to change the time:
Turn the top knob on the front panel to change the time location. When it is
set to the correct number, click outside the box to enter the change.
Click the keypad button to the left of the number entry box. Use the pop-up
keypad to enter a setting for the time location to perform.
Using the keyboard to directly input the desired value.
Click the Dist BW(MHz) box to change the distortion bandwidth frequency. This
setting applies only to the RMS Distortion measurement.
There are three ways to change the frequency:
Turn the top knob on the front panel to change the frequency location. When
it is set to the correct number, click outside the box to enter the change.
Click the keypad button to the left of the number entry box. Use the pop-up
keypad to enter a setting for the frequency location to perform.
Using the keyboard to directly input the desired value.
The next time the Frequency Response measurement is run, it will run with the
newly entered numbers.
Setting Up the Multiburst Measurement
Option SD/HD
To set up the Multiburst measurements, select Results > Multiburst to display the
result panel. The results panel for the measurement shows the settings that can be
changed for the measurement. For Multiburst, you can choose the line on which
the measurement is made, and the number of times the measurement is averaged.
To change settings for the Multiburst measurements:
1. Select Results > Multiburst.
2. To change the setting for Line Number, click the Line Number box.
VM5000 Automatic Video Measurement Set User Manual 3-73