C:\Documents and Settings\Allen - MSAWorld.com

2. Disconnect the timer wire. Using a 1/4” nut driver,
remove the (2) screws holding the switches to the
accumulator bracket and lift the switches and the
switch arms off.
Removing drive and switch cams:
1. Disconnect power and remove the accumulator from
the coin box.
2. Remove the “C” clamp and spacer washer, lift the
drive cam and the switch cam off the shaft.
Removing accumulator motor:
1. Disconnect power and remove the accumulator from
the coin box.
2. Using a # 1 Phillips screwdriver, remove the (2) screws
holding the motor to the accumulator bracket and
slide the motor out of the timing cam.
Note:
When installing the drive cam, be sure the
pin on the drive cam is behind and touching
the pin on the switch cam.
Removing timing cam:
1. Disconnect power and remove accumulator cover.
52