33 12 16.26 - 001-A - Butterfly Valves - Garney Construction

15
6.4 Connecting to Terminals
On EExde enclosure units connections
to the power and control terminals
must be made using AMP type 160292
ring tabs for power and earth terminals
and AMP type 34148 ring tabs for the
control terminals.
Refer to the wiring diagram inside the
terminal cover to identify functions of
terminals. Check that supply voltage is
the same as that marked on the
actuator nameplate.
Remove power terminal screen.
Begin by connecting these cables and
replace screen.
When all connections are made ensure
wiring diagram is replaced in the
terminal compartment.
6.5 Replacing Terminal Cover
Ensure cover “O” ring seal and spigot
joint are in good condition and lightly
greased before re-fitting cover.