MAX9272 28-Bit GMSL Deserializer for Coax or STP Cable

MAX9272
28-Bit GMSL Deserializer for Coax or STP Cable
Link Startup Procedure
Table 9 lists the startup procedure for video-display
applications. Table 10 lists the startup procedure for
image-sensing applications. The control channel is available
after the video link or the configuration link is established.
If the deserializer powers up after the serializer,
the control channel becomes unavailable until 2ms after
power-up.
Table 9. Startup Procedure for Video-Display Applications
NO. µC SERIALIZER DESERIALIZER
— FC connected to serializer.
Sets all configuration inputs. If any
configuration inputs are available on
one end of the link but not on the other,
always connects that configuration input
low.
Sets all configuration inputs. If any
configuration inputs are available on
one end of the link but not on the other,
always connects that configuration input
low.
1 Powers up. Powers up and loads default settings. Powers up and loads default settings.
2
Enables configuration link by
setting CLINKEN = 1 (if not
enabled automatically) and gets
an acknowledge. Waits for link to
be established (~3ms).
Establishes configuration link.
Locks to configuration link signal.
3
Writes one link configuration
bit (DRS, BWS, or EDC) in
the deserializer and gets an
acknowledge.
—
Configuration changed from default
settings (loss-of-lock can occur when
BWS or EDC changes).
4
Writes corresponding serializer
link configuration bit and gets an
acknowledge.
Configuration changed from default
settings.
Relocks to configuration link signal.
5
Waits for link to be established
(~3ms) and then repeats steps 3
and 4 until all serial link bits are
configured.
— —
6
Writes remaining configuration
bits in the serializer/deserializer
and gets an acknowledge.
Configuration changed from default
settings.
Configuration changed from default
settings.
7
Enables video link by setting
SEREN = 1 and gets an
acknowledge. Waits for link to be
established (~3ms).
Begins serializing data.
Locks to serial link signal and begins
deserializing data.
34