28.12.2014 Views

Leonardo 250-300 Repair Manual 2004 - Wheels Academy

Leonardo 250-300 Repair Manual 2004 - Wheels Academy

Leonardo 250-300 Repair Manual 2004 - Wheels Academy

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

CYCLE PARTS<br />

LEONARDO <strong>250</strong> - <strong>300</strong><br />

7.5.2. REMOVAL<br />

WARNING<br />

While disassembling/reassembling the wheel,<br />

take care not to damage the brake pipe, the<br />

disc and the pads.<br />

• Position the vehicle on the central stand.<br />

WARNING<br />

Place a support under the vehicle, so that the<br />

front wheel has enough space to move and the<br />

vehicle cannot fall down.<br />

• Unscrew and remove the two screws (9).<br />

• Remove the brake caliper (10), by carefully withdrawing<br />

it from the brake disc.<br />

• Loosen the screw of the wheel pin clamp (11).<br />

• Lock the wheel pin (12) by means of an hexagon<br />

spanner.<br />

• Unscrew and remove the nut (13), taking the washer.<br />

• Push the wheel pin (12), by carefully working on the<br />

threaded end and using a rubber hammer if necessary.<br />

NOTE Check the arrangement of the parts, washers and<br />

spacer ring, in order to be able to reassemble them correctly.<br />

• Support the front wheel and extract the wheel pin<br />

manually.<br />

• Remove the wheel.<br />

• Disconnect the tang of the speedometer/odometer control<br />

(6).<br />

WARNING<br />

Never pull the front brake lever after removing<br />

the wheel, otherwise the caliper piston may go<br />

out of its seat, thus causing the outflow of the<br />

brake fluid.<br />

• Take the washer and the spacer ring.<br />

7 - 48

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!