Leonardo 250-300 Repair Manual 2004 - Wheels Academy
Leonardo 250-300 Repair Manual 2004 - Wheels Academy
Leonardo 250-300 Repair Manual 2004 - Wheels Academy
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
LEONARDO <strong>250</strong> - <strong>300</strong><br />
PERIODIC MAINTENANCE<br />
2.2. BATTERY<br />
2.2.1. BATTERY<br />
There are two types of batteries available in the market:<br />
- batteries that require maintenance, fitted with cell plugs;<br />
- maintenance-free batteries, which have no cell plugs as<br />
they do not need inspecting or topping-up.<br />
After the first 621 mi (1000 km) and every 3728 mi (6000 km)<br />
or 12 months thereafter, check the electrolyte level and the<br />
tightness of the battery terminal clamps.<br />
DANGER<br />
The battery electrolyte is a toxic, caustic substance<br />
containing sulphuric acid and thus able<br />
to cause severe burns in case of contact.<br />
Always wear protective clothes, a mask and/or<br />
safety goggles when handling this fluid.<br />
If any battery fluid gets on your skin, rinse the<br />
affected area with abundant fresh water.<br />
If battery fluid is spilled into your eyes, flush<br />
with abundant water for fifteen minutes and<br />
contact an eye specialist immediately.<br />
If battery fluid is swallowed accidentally, drink<br />
abundant water or milk. Seek medical attention<br />
immediately and keep drinking milk of magnesia<br />
or vegetable oil in the meantime.<br />
The battery gives off explosive gases. Keep the<br />
battery well away from any sources of ignition,<br />
such as flames, sparks, or any heat sources.<br />
Charge or use the battery in a well-ventilated<br />
place. Do not inhale the gases produced by the<br />
battery under charging.<br />
KEEP AWAY FROM CHILDREN<br />
Take care not to tilt the vehicle too far as the<br />
battery fluid may spill out.<br />
WARNING<br />
Never invert the connection of the battery cables.<br />
Set the ignition switch to " " before connecting<br />
or disconnecting the battery.<br />
Connect first the positive cable (+) and then the<br />
negative cable (-).<br />
Disconnect in the reverse order.<br />
2 - 5