Leonardo 250-300 Repair Manual 2004 - Wheels Academy
Leonardo 250-300 Repair Manual 2004 - Wheels Academy
Leonardo 250-300 Repair Manual 2004 - Wheels Academy
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
LEONARDO <strong>250</strong> - <strong>300</strong><br />
FUEL SYSTEM<br />
4.1.2. REMOVING THE FUEL TANK<br />
• Position the vehicle on the central stand.<br />
WARNING<br />
Wait until the engine and the exhaust silencer<br />
have completely cooled down.<br />
• Remove the footrest, see 7.1.5 (REMOVING THE<br />
FOOTPEG).<br />
• Remove the lower shield, see 7.1.8 (REMOVING THE<br />
LOWER SHIELD).<br />
WARNING<br />
Fuel vapours are noxious. Before proceeding,<br />
make sure that the room in which you are working<br />
is properly ventilated. Do not inhale fuel vapours.<br />
Neither smoke, nor use free flames. Do<br />
not dispose of fuel in the environment.<br />
• Drain the fuel tank completely.<br />
• Put the fuel in a container, plug it and keep it in a safe<br />
place.<br />
WARNING<br />
Mark the pipes, in order to be able to reconnect<br />
them correctly.<br />
• Withdraw the two pipes (1-2) from the connections on<br />
the filler neck.<br />
• Disconnect the electric connector (3) from the fuel level<br />
gauge unit.<br />
• Working on the lower part of the vehicle, unscrew and<br />
remove the screw (4) and take the relevant washer.<br />
NOTE Before inserting the screw (4) (right side of the vehicle),<br />
position the guide of the accelerator cable and of the<br />
rear brake pipe.<br />
• Remove the whole fuel tank, withdrawing it from below.<br />
4 - 5
Change language