19” HD Ready Digital LCD TV with DVD Player - KnowHow

Preparation Connections Initial Setup Using the Features Using the Features DVR (Digital
via USB port Video Recorder)
Using the DVD
Features
Hints and Tips, Specification
and Safety Warnings
Hints and Tips
If a problem does occur, it may often be due to something very minor. The following table contains various tips.
The TV does not operate properly.
The remote control does not work
Power is suddenly turned off
The video function does not work.
No Picture & No Sound
Picture appears slowly after
switching on
No or poor colour or poor picture
Horizontal / Vertical bar or picture
shaking
Poor reception on some channels
GB-52
• Check to see if there are any objects between the TV and the remote control
causing an obstruction. Ensure that you are pointing the remote control directly at
the TV.
• Ensure that the batteries are installed with correct polarity (+ to +, – to –).
• Install new batteries.
• Check the power of the TV. The mains supply maybe interrupted.
• Check if the sleep timer is set.
• Check whether the Auto Sleep is activated.
• Check whether the TV is switched on.
• Try another channel. The problem may be caused by the broadcaster.
• This is normal, the image is muted during the TV startup process. Please contact
your service centre, if the picture has not appeared after five minutes.
• Adjust the settings in the PICTURE menu.
• Try another channel. The problem may be caused by the broadcaster.
• Check if the video cables are connected properly.
• Check for local interference such as an electrical appliance or power tool.
• Station or cable channel may be experiencing problems, tune to another station.
• Station signal is weak, reposition the aerial for better reception.
• Check for sources of possible interference.
Lines or streaks in pictures • Check aerial (Change the position of the aerial.)
No pictures when connecting HDMI • Check if the input source is HDMI.
The audio function does not work.
Picture OK but no sound
• Press the VOL +/– buttons.
• Sound muted? Press the button.
• Try another channel. The problem may be caused by the broadcaster.
No output from one of the speakers • Adjust the Balance settings in the SOUND menu.
Unusual sound from Inside the TV
No sound when connecting HDMI • Check if the input source is HDMI.
• A change in ambient humidity or temperature may result in an unusual noise when
the TV is switched on or off and does not indicate a fault with the TV.
Audio noise • Keep the RF coaxial cable away from the other connected cables.
Password
Lost password
The DVR function does not work.
One button recording / timer
programming does not work
• Select the Child Lock setting in the FUNCTION menu, then enter the following
master password “8899”. The master password clears your previous password and
allows you to enter a new password.
• Check if the TV is in DTV mode.
• Check the connection of the external USB storage device.
• Check if the capacity of the USB storage device is full.
Logik L19DVDP10_B20_IB_100914_Zell.indd 52 14/09/2010 3:03 PM