User's Manual ZA-200 / ZA-250

Paperfeeding
If cut sheet paper (without ASF) is not feeding smoothly, check the
following:
Check
Is the paper release lever
pushedfront(to the~ position)
Is the paper guide in place
and vertical
Are the left andrightguides
too close together
Is the ASF selected with the
Memory Switch settin~
Are you trying to feed paper
using the frontpanelbuttons
white the ONLINEindicator
illuminated
Is the paper toothick
Are forms jammingbetween
printing surface and the
platen
Possible remedy
Set the release lever to the ~
position.
Thepaperguideshouldbe inplace andverticallyforcut
sheets to feed smoothly.
If the left and right guides me too close together, the
paper will not feed smoothly. Move them a little further
auart to allow the pauer feed freely.
If it is, then deselect it.
You can only feed paper in this way the printer is offline.
Set the printer off-line and then feed paper.
There are limits to the thickness of paper that can be fed
in this way. Trv with thinner uamx.
Clean the surface of theplatenroller with a cloth barely
dampendcd with a little alcohol.
Iffanfold(continuous)paperisnotbeingfedcotnctly usingtheaactorfeed,
checkthe following:
Check
Possible remedy
Is the paper release lever Makesuretherelease lever ispushcdto the ~ position.
pushed to the ~ position
Is the paper guide in the ver- When using the tractor feed, the paper guide should be
tical position
horizontal.
Are the holes on each side of If thetwosides of thepaperareoutof alignment, realign
the paper aligned with regard them so that the tractor holes match up.
to each other in the tractor
units
Arethetractorunits tooclose Misalignment of the tractor units, making the paper too
or too far apart
close or too tight, will prevent a smooth paper feed.
Are the ~actor units locked
in position and the covers
closed
Correct this if necessary.
132