User's Manual ZA-200 / ZA-250
User's Manual ZA-200 / ZA-250
User's Manual ZA-200 / ZA-250
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Check<br />
Is the paper feeding freely<br />
into the printer<br />
Is thepapercaughtup wound<br />
the perforation<br />
You can only feed paper in this way the printer is eff-<br />
line. Set the printer off-line and then feed paper.<br />
Are you trying to feed paper<br />
using the fiontpanel buttons<br />
while the ON LINEindicator<br />
illuminated<br />
Is the paper too thick<br />
Possible remedy<br />
The paper should not be too fw from the printer (less<br />
than 1 meter/3 feet), and there should be no cables or<br />
other obstacles obstructing its path. The paper should<br />
also be feeding straight into the printer, and an angled<br />
feed may cause jams and blockages.<br />
It isrecommended to skip around the perforation. If you<br />
cannoL set on the CR-CENTERING with Memory<br />
seitch.<br />
There are limits to the thickness of paper that can be fed<br />
in this way. Try with thinner paper.<br />
J<br />
If the ASF is not operatingor is not feedingpaper correctly,check the<br />
following:<br />
Check ‘“ Possible remedy<br />
Haa the cormxt ASF option<br />
been selected with the<br />
Memory Switch<br />
Select correct option.<br />
Is the release lever set to the The release lever should be set to the single-sheet<br />
~ position position.<br />
Is the ASF correctly Make sure that the ASF improperlyseated on the printer.<br />
mounted<br />
Is paper caught up near the<br />
print head ~<br />
Are theleft and right guides<br />
too clo.ie together<br />
Is there too much paper in the<br />
paper feed hopper or stacker<br />
Was the paper fanned before<br />
being fed into the ASF<br />
Has the paper bear used already<br />
or is it creased<br />
You can only feed paper in this way the printer is eff-<br />
line. Set the printer off-line and then feed paper.<br />
Are you trying to feed paper<br />
using the llont panel buttons<br />
while the ONLINEindicator<br />
illuminated<br />
Is thepapertoothick or too<br />
thin<br />
Stop printing, remove thejammed sheet (you may have<br />
to rcmove the ASF for this), and continue.<br />
If the left and right guides are too close together, the<br />
paper will not feed smoothly. Move them a little further<br />
armrt to allow the Dauerto feed freelv.<br />
The ASF’S paper feed hopper and stacker can hold<br />
between 100to 150 sheets each. Make sure that there is<br />
no more paper than this in either the hopper or stacker.<br />
If this is not done, paper jams may occur. Remove the<br />
stack of paper from the ASF and fan it before<br />
reinserting.<br />
Only new, uncreased paper should be used with the<br />
ASF.<br />
There arc limits to the thickness of paper that can be fed<br />
in this way. Try with different paper.
Change language