BZ-33, 44 Series - Waltco
BZ-33, 44 Series - Waltco
BZ-33, 44 Series - Waltco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 4<br />
Liftgate Installation<br />
WELDING, CUTTING AND GRINDING<br />
Before doing any metal work:<br />
Pull pump unit out from main frame and cover with<br />
non flammable material.<br />
Cover piston rods with non flammable material.<br />
PULL PUMP<br />
UNIT OUT<br />
Welding, torching or grinding can damage<br />
cylinders, hoses or electrical system.<br />
COVER<br />
GR00508<br />
WELDING<br />
Welding machines ground point must connected as<br />
close to welding point as possible.<br />
Do not allow ground current go through pivot pins,<br />
bearings, cables or hydraulic hoses.<br />
Welding current can melt cables or burst<br />
hoses causing personal injury.<br />
DO NOT<br />
GROUND<br />
WELDING<br />
MACHINE TO<br />
CYLINDERS<br />
GR00508<br />
PAINTING<br />
IMPORTANT! Do not paint the cylinder piston rods!<br />
Any paint applied to piston rods will eventually effect the<br />
operation of liftgate by contaminating the entire<br />
hydraulic system, causing blockages in valves, pump,<br />
filter, cylinders, and hoses.<br />
DO NOT ALLOW<br />
ANY PAINT ON<br />
PISTON RODS!<br />
GR00508<br />
FINAL INSTALL OF MOUNT BRACKETS<br />
(WELD METHOD)<br />
Lower platform to the ground.<br />
Weld mount brackets to chassis frame 100% as shown.<br />
GR00093<br />
27