BZ-33, 44 Series - Waltco
BZ-33, 44 Series - Waltco
BZ-33, 44 Series - Waltco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 4<br />
ADJUSTING TILT DOWN ANGLE<br />
Liftgate Installation<br />
Note: To obtain the correct tilt down function, it is<br />
necessary to follow the previous instructions which<br />
ensure a correct 90° tilt angle up against the truck’s<br />
body.<br />
Cycle the lift up until it reaches floor level.<br />
GR02829<br />
Loosen the cylinder ring’s lock screw (1). Screw the ring<br />
out in the direction of the platform (2)<br />
Tilt the platform a maximum of 10° below the horizontal<br />
as shown in Fig-GR02829<br />
1<br />
2<br />
GR02816<br />
Tighten the ring to the top of the cylinder (3) and then<br />
tighten the lock screw into the ring (4) after tilt down<br />
angle is established<br />
4<br />
3<br />
GR02817<br />
Reassemble the rubber bellows as shown to the<br />
following A dimensions:<br />
Liftgate Model:<br />
Short Arm<br />
A: (inches)<br />
7 <br />
± <br />
<br />
~ 3/8”<br />
Long Arm<br />
11 <br />
± <br />
<br />
Test all the functions of liftgate.<br />
Make sure that platform fits properly against top sill (if so<br />
equipped).<br />
GR02818<br />
31