STARTING GUIDE FRENIC-Eco . FRN-F1 - Welcome to Fuji Electric

Timing scheme:
ISW50
COMMERCIAL POWER
INVERTER OPERATION OPERATION
INVERTER OPERATION
Inverter is controlling the motor
speed
The function codes which have been modified are:
The motor speed is
fixed to commercial
power speed
The inverter starts to harmonize the motor from the
commercial power operation to the inverter desired
speed.
Inverter is controlling the motor
speed
Code Data Description
F02 1 RUN command using terminals (digital inputs)
F03 motor data Maximum frequency
F04 motor data Base frequency
F05 motor data Rated voltage
F07 15 s (for instance) Acceleration time
F08 15 s (for instance) Deceleration time
E01 0 SS1 multistep frequency function assigned to X1 terminal (digital input)
E02 40 Switching sequence command ISW50 assigned to X2 terminal (digital input)
E20 12 SW52-1 function assigned to Y1 terminal (digital output)
E21 13 SW52-2 function assigned to Y2 terminal (digital output)
E22 11 SW88 function assigned to Y3 terminal (digital output)
E46 1 Language selection (English language selected)
C05 10 Hz (for instance) If X1 terminal is ON, C05 speed will be selected
P01 motor data Number of motor poles
P02 motor data Motor capacity
P03 motor data Motor rated current
P06 motor data Motor no load current (for instance 50% of P03). If autotuning mode 2 is done, P06 is auto calculated.
H13 2 seconds Restart time
Chapter 6: Function codes and application example 27