ToneLab SE Owner's manual - Vox
ToneLab SE Owner's manual - Vox
ToneLab SE Owner's manual - Vox
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
1. Press the GLOBAL button (3.4).<br />
2. Press the √, ® buttons (3.2) to make the name display (3.8) read “CCHG I/O.”<br />
3. Specify whether all control change messages will be transmitted or received.<br />
Use value knob 6 (2.2) or the ▲, ▼ buttons (3.1) to make your choice.<br />
“On” allows transmitting and receiving. “OFF” disables transmitting and receiving.<br />
NOTE: If this setting is “OFF,” no control change messages will be transmitted or<br />
received even if you specify individual control change numbers in step 4.<br />
4. Simultaneously press both √, ® buttons (3.2) to access the screen where you<br />
can set control numbers individually. Use the √, ® buttons to select each controller.<br />
The controllers will be selected in the following order.<br />
“EXP1 PDL” Expression pedal 1 control<br />
“EXP2 PDL” Expression pedal 2 control<br />
“CTRL PDL” Control pedal on/off<br />
“VOL PDL”: VOLUME pedal control<br />
“TAP SW”: TAP switch on/off<br />
“PEDAL FX”: PEDAL effect on/off<br />
“MOD FX”: MODULATION effect on/off<br />
“DELAY FX”: DELAY effect on/off<br />
“REVRB FX”: REVERB effect on/off<br />
“INSRT FX” External effect on/off<br />
“A/B CH” Channel A/B<br />
5. For each controller, specify whether <strong>ToneLab</strong><strong>SE</strong> will transmit and receive control<br />
change messages. If you want <strong>ToneLab</strong><strong>SE</strong> to transmit and receive messages for<br />
a controller, specify the control change number. Select a controller, and use<br />
value knob 6 (2.2) or the ▲, ▼ buttons (3.1) to make the desired setting.<br />
“OFF”: Control change messages will not be transmitted or received.<br />
“CC00”–“CC95”: When you operate a controller, messages of the specified<br />
control change number 00–95 will be transmitted. Similarly, <strong>ToneLab</strong><strong>SE</strong> will be<br />
controlled when it receives messages of the same control change number<br />
from an external MIDI device.<br />
6. To return to the screen where you specify transmit or receive for all control<br />
change messages, press both √, ® buttons (3.2) simultaneously.<br />
PARAMETER CHANGE (GLOBAL “SYEX OUT”)<br />
When you operate <strong>ToneLab</strong><strong>SE</strong>’s knobs or buttons to edit the value of a parameter,<br />
system exclusive such as parameter changes are transmitted.<br />
If you want <strong>ToneLab</strong><strong>SE</strong>’s parameters to be transmitted to an external device, turn<br />
the “SYEX OUT” setting “On.” Normally, you will turn “SYEX OUT” on when using<br />
the Sound Editor.<br />
This setting specifies whether <strong>ToneLab</strong><strong>SE</strong> will transmit parameter changes.<br />
Tuner<br />
Pedals<br />
MIDI/DIGITAL<br />
Factory<br />
settings<br />
Troubleshooting<br />
Spec.<br />
Program<br />
List<br />
61