ToneLab SE Owner's manual - Vox

Troubleshooting
If you suspect a malfunction, please check the following points first. If this does
not resolve the problem, please contact your dealer or Vox authorized service
center.
1. The amp isn’t powering up when the STANDBY switch is
“on”
• Is the AC/AC power supply connected to the rear panel ~AC9V jack?
• Is the AC/AC power supply plugged into an AC outlet?
• Is the STANDBY switched on?
• Could the AC/AC power supply be damaged?
2. There’s no sound
• Is your guitar turned up?
• Are both ends of your guitar cable plugged into the correct jacks?
• Is your guitar cable working?
• Could the rear panel OUTPUT LEVEL knob be turned down?
• Check the GAIN, TREBLE, MIDDLE, BASS, VR GAIN, and CH VOLUME settings.
For some amp types, you might not hear any sound if the TREBLE, MID-
DLE, and BASS settings are turned down – just like the circuitry on the original
amp!
If you are using a pedal effect, check the DRIVE [1] and LEVEL [3] settings as
well.
• Could an expression pedal be at the minimum position with a parameter such
as DRIVE, LEVEL, VOLUME, GAIN, or VR GAIN assigned to it?
• Could you have activated the Mute function? Press the FX ON/OFF (TUNER)
pedal to defeat muting.
3. You can't hear any effects even though they're dialed in...
• Are the effect LEDs lit?
If an LED is dark, the corresponding effect is off.
Press the MODE select button to turn on the effect.
• Could the modulation “DEPTH” or the delay/reverb “MIX” be set to a low value?
Press the MODE select button to select an effect and use the value knobs to
adjust the appropriate parameters.
• Could the effect be bypassed?
If so, press the FX ON/OFF pedal to cancel bypass.
Tuner
Pedals
MIDI/DIGITAL
Factory
settings
Troubleshooting
Spec.
Program
List
65