SAM PuttLab Operating Manual - Science & Motion Golf

More documents

Recommendations

Info

Hardware and Software Installation 1.10 Hardware and Software Installation Welcome to the Hardware and Software Installation. If you experienced problems during the completion of the installation with the "Quick-Start-Guide", you can recheck the single steps here again with a more detailed description. Of course you can use this guide for the complete installation without the "Quick-Start-Guide" too. If you haven't installed the system like described in the "Quick-Start-Guide", please remember to: • Maintain the sequence of the steps to avoid problems during the installation. • Don't connect the Basic Unit to your PC until instructed to do so in this guide. • If any component of the SAM PuttLab gets abnormally hot after connecting please abort the installation and contact the SAM Support Help Desk. Page 18
Hardware and Software Installation 1.10.1 Installing the Triplet Components needed: Triplet Batteries Battery Clip Triplet Calibration Sheet 1. Insert batteries into battery clip • Open the battery case on the backside of the battery clip by sliding down the access cover. • Insert the batteries into the battery clip as shown in the inset Avoid polarity reversal! • Close the battery case. Battery Clip Avoid polarity reversal ! Page 19
Page 1 and 2: SAM PuttLab Operating Manual Versio
Page 3 and 4: Table of Contents 1.1 Table of Cont
Page 5 and 6: Table of Contents 3.9 Games .......
Page 7 and 8: A Word from the Inventor 1.3 A Word
Page 9 and 10: Functionality of SAM PuttLab 1.4.2
Page 11 and 12: Functionality of SAM PuttLab differ
Page 13 and 14: Soft- and Hardware Requirements 1.7
Page 15 and 16: Safety Warnings About the Power Sup
Page 17: Transport and Storage 1.9 Transport
Page 21 and 22: Hardware and Software Installation
Page 33 and 34: Start the SAM PuttWare software The
Page 35 and 36: Start the SAM PuttWare software 2.1
Page 37 and 38: Quick Overview of Project and Playe
Page 39 and 40: First Measurement 2.4 First Measure
Page 41 and 42: Open a Result Report 2.5 Open a Res
Page 43 and 44: The Main Screen selected. • The s
Page 45 and 46: The Main Screen Print, Profile - Di
Page 47 and 48: The Main Screen In the listboxes yo
Page 49 and 50: The Main Screen 3.1.4 Main Menu Ite
Page 51 and 52: The Main Screen This function creat
Page 53 and 54: The Main Screen Device diagnosis Op
Page 55 and 56: The Main Screen Registration This w
Page 57 and 58: Settings 3.3 Settings "Recording Se
Page 59 and 60: Calibration 3.4 Calibration 3.4.1 G
Page 61 and 62: Calibration Calibration position to
Page 63 and 64: Calibration To start the calibratio
Page 65 and 66: Measurement 3.5 Measurement There a
Page 67 and 68: Measurement 2. Depending on the cal
Page 69 and 70:
Measurement 3.5.2 Measurement scree
Page 71 and 72:
Training Click the "Start" button a
Page 73 and 74:
Training You can also browse throug
Page 75 and 76:
Training Sound - Turns event sounds
Page 77 and 78:
Manual Recording 1) Be sure the sys
Page 79 and 80:
Viewing the Results In the print re
Page 81 and 82:
Viewing the Results Browse one page
Page 83 and 84:
Viewing the Results 3.8.3 Competenc
Page 85 and 86:
Games 3.9 Games Games are not avail
Page 87 and 88:
Games 3.9.1 Game Settings With the
Page 89 and 90:
Games 3.9.2 Games description After
Page 91 and 92:
Games After all players completed t
Page 93 and 94:
3D putt replay 3.10.1 General overv
Page 95 and 96:
3D putt replay The first value in r
Page 97 and 98:
3D putt replay 4) data value select
Page 99 and 100:
Data management 3.11.1 How to set u
Page 101 and 102:
Data management Add / Create a new
Page 103 and 104:
Data management Please note: If you
Page 105 and 106:
Data management 3.11.3 Player manag
Page 107 and 108:
Data management Edit player Select
Page 109 and 110:
Data management Select a measuremen
Page 111 and 112:
Data management box will be exporte
Page 113 and 114:
Data management If you selected an
Page 115 and 116:
Using 4 data channels for recording
Page 117 and 118:
Using 4 data channels for recording
Page 119 and 120:
Additional Reports After measuremen
Page 121 and 122:
Extended data analysis functions 4.
Page 123 and 124:
Extended data analysis functions Ca
Page 125 and 126:
Extended data analysis functions Th
Page 127 and 128:
Page 129 and 130:
Extended data analysis functions Sc
Page 131 and 132:
Extended data analysis functions po
Page 133 and 134:
Page 135 and 136:
Extended data analysis functions Pr
Page 137 and 138:
Extended data analysis functions 20
Page 139 and 140:
Extended data analysis functions or
Page 141 and 142:
A Technical Troubleshooting Some fu
Page 143:
Technical Data Triplet Dimensions:
show all

SAM PuttLab Operating Manual - Science & Motion Golf

Create successful ePaper yourself

Delete template?

Save as template?