SAM PuttLab Operating Manual - Science & Motion Golf

Measurement
2. Depending on the calibration method you have chosen in
the settings (default = calibration by pressing key) you
need to calibrate the system (read chapter 3.4).
3. At the top right of the window you can see
the field "Markers". It indicates whether the
3 sensors are having connection to the Basic
Unit. If you are in the measuring range the
color of the sensors should be green. A red
color indicates interrupted connection (e.g.
in case club is out of measuring range).
4. The box shown below provides you with informations on the
current measurement. You can see the currently selected
Project and Player name, the date, the number of already
processed putts and the number of total putts to be
recorded.
5. On the lower edge you can see a realtime display of our
club head alignment to the target. You will see your current
misalignment in the graphics and as number in degrees. If
you have calibrated the system correctly in step 2, the
alignment of your club should be green and the height
should be around 0 mm when you aim to the target. If not,
press [C] to re-calibrate.
This display will additionally show the current values for
relative lie angle, absolute lie angle and shaft angle.
Page 67