SAM PuttLab Operating Manual - Science & Motion Golf
SAM PuttLab Operating Manual - Science & Motion Golf
SAM PuttLab Operating Manual - Science & Motion Golf
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Hardware and Software Installation<br />
5. Fasten triplet nuts<br />
lightly<br />
Now fasten both triplet nuts<br />
evenly until the triplet is<br />
fixed lightly on the shaft.<br />
Don’t fix<br />
aslope !<br />
The fastener must not be<br />
fixed aslope as displayed in<br />
the right picture.<br />
6. Check alignment<br />
against clubhead -<br />
then fasten nuts firmly<br />
Place the club head on the<br />
triplet calibration sheet.<br />
Adjust the angle between<br />
club head and triplet to 90<br />
degrees.<br />
Tip: You might lift up your<br />
golf club and look over<br />
the shaft to verify that<br />
the angle is 90 degrees.<br />
Finally fasten the triplet<br />
nuts firmly.<br />
90°<br />
7. Connect the tripletcable<br />
to the battery clip<br />
Unlock the outer ring at the<br />
end of the triplet cable by<br />
turning it to the left.<br />
Connect the cable to the<br />
battery clip and lock it by<br />
turning the outer ring to<br />
to the right.<br />
Page 21
Change language