SAM PuttLab Operating Manual - Science & Motion Golf

Calibration
3.4.3 Countdown Calibration
The "Countdown Calibration" method is based on a countdown
timer that runs for a pre-defined time. At the end of the timer the
calibration will be done automatically by using the club head
position at this time. This is a good way to calibrate the system
without having to press a key on the keyboard (e.g. if no second
person is around).
The timer runs through two phases:
1) Phase one (progress bar is running over green area)
During this phase you have time to prepare your address position,
i.e.:
• move to address position
• set club head on the ground
• align club head to target
• adjust club head to sweet spot position (relative to the ball)
2) Phase two (progress bar is running in blue area)
During this phase of the calibration try to hold your club head
stable in your address position. At the end of this phase the
software will automatically detect your calibration position.
Page 62