SAM PuttLab Operating Manual - Science & Motion Golf

The Main Screen
Device diagnosis
Opens the "device diagnosis"
window. Here you can check if
the system hardware is working
properly.
To check the system:
a) Attach the battery clip and turn it on by pressing the
button.
b) Open the "Device diagnosis" from the main menu.
c) Move the club with triplet (or triplet alone) in front of the
basic unit.
d) The front side of the triplet must show into direction of the
basic unit.
e) Move the triplet around in distance of 50 to 100 cm to the
basic unit and check if all three signal lamps (Marker1 to
Marker3) become green. If this is the case the system is
OK.
The signals should stay green while moving around in the
normal operational area.
If one of the signal lamps never gets green probably one
sensor (ultrasonic marker) of the triplet is defective.
If none of the signal lamps are turning green check the following:
a) Check the LED light on the battery clip:
If it is blinking red, batteries are low. Exchange the batteries
and try again.
b) Check the LED light on the battery clip:
If it is off, the system is not activated or the batteries are
dead. Try to activate the system by pressing the button. If
nothing happens exchange the batteries and try again.
Page 53