28.04.2015 Views

TC63i AT Command Set

TC63i AT Command Set

TC63i AT Command Set

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

<strong>TC63i</strong> <strong>AT</strong> <strong>Command</strong> <strong>Set</strong><br />

<br />

7.15 <strong>AT</strong>S7<br />

7.15 <strong>AT</strong>S7 <strong>Set</strong> number of seconds to wait for connection completion<br />

<strong>AT</strong>S7 specifies the number of seconds the TA will wait for the completion of the call setup when answering or<br />

originating a data call. Also referred to as "no answer timeout". To put it plainly, this is the time to wait for the<br />

carrier signal. If no carrier signal is received within the specified time, the TA hangs up.<br />

Syntax<br />

Read <strong>Command</strong><br />

<strong>AT</strong>S7?<br />

Response(s)<br />

<br />

OK<br />

Write <strong>Command</strong><br />

<strong>AT</strong>S7=<br />

Response(s)<br />

OK<br />

ERROR<br />

PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge Last Reference(s)<br />

- + - + + - - - + - V.250<br />

Parameter Description<br />

(num)(&W)(&V)<br />

Number of seconds to wait for connection completion<br />

000...060 (&F)<br />

Notes<br />

• <strong>Command</strong> <strong>AT</strong>S7 is only applicable to data calls.<br />

• Values greater than 60 (maximum 255) cause no error, but will be restored to the maximum value of 60.<br />

• The correlation between <strong>AT</strong>S7 and <strong>AT</strong>S0 is important. If the called party has specified a high value for<br />

<strong>AT</strong>S0= call setup may fail.<br />

Example: Call setup may fail if <strong>AT</strong>S7=30 and <strong>AT</strong>S0=20.<br />

<strong>TC63i</strong>_<strong>AT</strong>C_V01.100 Page 172 of 547 11/10/08<br />

Confidential / Released

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!