TC63i AT Command Set

TC63i AT Command Set
8.2 AT+COPS
Read Command
AT+COPS?
Response(s)
+COPS:[, [, ]]
OK
ERROR
+CME ERROR:
Write Command
AT+COPS=[, [, ]]
Response(s)
OK
ERROR
+CME ERROR:
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge Last Reference(s)
± + + + + + + - - - GSM 07.07
Parameter Description
(num)
Status
0 Unknown
1 Operator available
2 Current operator
3 Operator forbidden
(str)
Operator
If test command: Operator name in long alphanumeric format and numeric format.
If read command: Operator name as per .
If write command: Operator name in numeric format.
(num)(&V)
Parameter values 0 and 1 are stored non-volatile in the TC63i.
0 (D) Automatic mode; field is ignored.
1 Manual operator selection
Write command requires in numeric format, i.e. shall be 2.
Read command returns the current and the currently selected
. If no operator is selected, and are omitted.
2 Manually deregister from network and remain unregistered until =0 or
1 or 4 is selected.
3 Set only (for AT+COPS read command).
4 Automatic / manual selection; if manual selection fails, automatic mode
(=0) is entered ( field will be present).
TC63i_ATC_V01.100 Page 196 of 547 11/10/08
Confidential / Released