TC63i AT Command Set

TC63i AT Command Set
19.2 AT+CALA
• Alarm settings on ASC0 / ASC1 and different Multiplexer channels (see AT+CMUX):
- On each interface an individual message can be stored, but only one time setting applies. This
means an alarm set on one of the interfaces overwrites the time setting on all remaining interfaces.
Therefore, the total number of alarm events returned by the read command AT+CALA? will always
be =0, no matter whether different text messages are stored.
- When the scheduled alarm occurs, the ME sends the URC only on the interface where the most recent
alarm setting was made. The alarm time will be reset to "00/01/01,00:00:00" on all interfaces.
Examples
EXAMPLE 1
You may want to configure a reminder message for July 31, 2005, at 9.30h, including the message "Good
Morning".
AT+CALA="05/07/31,09:30:00",0,0,"Good Morning"
OK
Do not switch off the GSM engine.When the alarm occurs the ME returns the following URC:
+CALA: Good Morning
EXAMPLE 2
To set a fresh alarm using the same message as in Example 1, simply enter date and time. , ,
, can be omitted:
AT+CALA="05/07/31,08:50:00"
OK
When the alarm is executed the URC comes with the same message:
+CALA: Good Morning
EXAMPLE 3
To enable the ME to wake up into Airplane mode, e.g. on July 20, 2005, at 8.30h, enter
AT+CALA="05/07/20,08:30:00"
OK
Next, power down the ME:
AT^SMSO
^SMSO: MS OFF
OK
^SHUTDOWN
When the alarm is executed the ME wakes up to Airplane mode and displays a URC. If available, this line is
followed by the individual most recently saved. If no individual message was saved only the first line
appears.
"^SYSSTART AIRPLANE MODE"
+CALA: Good Morning
EXAMPLE 4
To delete an alarm before its scheduled time is reached enter an empty string for parameter . This
will restore the default time and clear any individual message defined with .
AT+CALA=""
OK
AT+CALA?
+CALA: "00/01/01,00:00:00",0,0,""
OK
TC63i_ATC_V01.100 Page 488 of 547 11/10/08
Confidential / Released