TC63i AT Command Set

TC63i AT Command Set
11.8 AT+CGEQREQ
11.8 AT+CGEQREQ Rel. 99 Quality of Service Profile (Requested)
Syntax
Test Command
AT+CGEQREQ=?
Response(s)
+CGEQREQ: , (list of supported s), (list of supported s), (list of supported s), (list of supported s),
(list of supported s), (list of supported s), (list of
supported s), (list of supported s), (list of supported
s), (list of supported s), (list of
supported s), (list of supported s)
OK
Read Command
AT+CGEQREQ?
Response(s)
[+CGEQREQ: , , , ,
, , , , , , ,
, ]
[+CGEQREQ: ...]
Write Command
AT+CGEQREQ=[[, [, [, [,
[, [, [, [, [, [, [, [, ]]]]]]]]]]]]]
Response(s)
OK
ERROR
+CME ERROR:
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge Last Reference(s)
+ + + + + + + - + - 3GPP TS 27.007
Command Description
The test command returns values supported as a compound value.
The read command returns the current settings for each defined context.
The write command allows the TE to specify a Quality of Service Profile for the context identified by the (local)
context identification parameter which is used when the MT sends an Activate PDP Context Request
message to the network.
A special form of the write command, AT+CGEQREQ= causes the requested profile for context number
to become undefined.
AT&F and ATZ will undefine the QoS profiles of every context which is not active or not online.
Parameter Description
(num)
Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and is
used in other PDP context-related commands.
1...2
TC63i_ATC_V01.100 Page 324 of 547 11/10/08
Confidential / Released