TC63i AT Command Set

TC63i AT Command Set
11.11 AT+CGQREQ
11.11 AT+CGQREQ Quality of Service Profile (Requested)
Syntax
Test Command
AT+CGQREQ=?
Response(s)
+CGQREQ: , (list of supported s), (list of supported s), (list of
supported s), (list of supported s), (list of supported s)
OK
Read Command
AT+CGQREQ?
Response(s)
[+CGQREQ: , , , , , ]
[+CGQREQ: ...]
Write Command
AT+CGQREQ=[[, [, [, [, [, ]]]]]]
Response(s)
OK
ERROR
+CME ERROR:
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge Last Reference(s)
+ + + + + + + - + - GSM 07.07
Command Description
The test command returns values supported as a compound value. If the MT supports several PDP types, the
parameter value ranges for each PDP type are returned on a separate line.
The read command returns the current settings for each defined context.
This command allows the TE to specify a Quality of Service Profile that is used when the MT sends an Activate
PDP Context Request message to the network.
The set command specifies a profile for the context identified by the (local) context identification parameter,
.
Please note, that the parameters of the requested QoS profile need to meet the following condition:
((AT+CGQMIN.= 0) OR (AT+CGQREQ. ≤ AT+CGQMIN.)) AND
((AT+CGQMIN.= 0) OR
(AT+CGQREQ. ≤ AT+CGQMIN.)) AND
((AT+CGQMIN.= 0) OR (AT+CGQREQ. ≥ AT+CGQMIN.)) AND
((AT+CGQMIN.= 0) OR
(AT+CGQREQ. ≤ AT+CGQMIN.)) AND
(AT+CGQREQ. ≥ AT+CGQMIN.)
If this condition is not fulfilled or the network does not support all of the requested QoS settings, then the activation
of the associated context will fail.
A special form of the set command, +CGQREQ= causes the requested profile for context number
to become undefined.
AT&F and ATZ will undefine the QoS profiles of every context which is not active or not online.
TC63i_ATC_V01.100 Page 333 of 547 11/10/08
Confidential / Released