TC63i AT Command Set

TC63i AT Command Set
11.16 AT^SGCONF
11.16 AT^SGCONF Configuration of GPRS related Parameters
Syntax
Test Command
AT^SGCONF=?
Response(s)
^SGCONF: (list of supported s), (list of supported s), (list of
supported es)
OK
Read Command
AT^SGCONF?
Response(s)
^SGCONF: , ,
OK
Write Command
AT^SGCONF=[][, [][, []]]
Response(s)
OK
ERROR
+CME ERROR:
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge Last
- + + + + + + - + -
Parameter Description
(num)
The maximum number of octets in an information field of Unnumbered (U) frames. Parameter is non-volatile.
0 No negotiation with network (500 will be used).
140...500 (D) ...1520 Lower values diminish performance.
(num)
The maximum number of octets in an information field of Combined Information (I) frames. Parameter is nonvolatile.
0 No negotiation with network (500 will be used).
140...500 (D) ...1520 Lower values diminish performance.
(num)
GPRS Multislot Class. The value can be one of the classes indicated with the Test command. The value set is
volatile and powerup value is the maximum allowed.
Note
• AT^SGCONF will respond with "+CME ERROR: operation temporary not allowed" if the module is already
GPRS attached (see AT+CGATT). The same error response is sent during background protocol stack activity,
e.g. during network registration.
TC63i_ATC_V01.100 Page 343 of 547 11/10/08
Confidential / Released