TC63i AT Command Set

TC63i AT Command Set
18.20 AT^SRTC
Parameter Description
(num)
Type of ring tone. You have a choice of 7 different ring tones and melodies. All will be played from the audio
output selected with the AT^SNFS command. =0 is only intended for muting.
0 Mutes the currently played tone immediately.
1 Sequence 1
2 Sequence 2
3 (D) Sequence 3
4 Sequence 4
5 Sequence 5
6 Sequence 6
7 Sequence 7
(num)
Volume of ring tone, varies from low to high
0 (D) Mute
1 Very low
2 Identical with 1
3 Low
4 Identical with 3
5 Middle
6 Identical with 5
7 High
(num)
Status of test ringing. Indicates whether or not a melody is currently being played back for testing
0 Switched off
1 Switched on
Notes
• Before first using ring tones note that the following settings apply:
We have chosen to let you decide your own preferences when you start using ring tones. Therefore, factory
setting is AT^SRTC=3,0,0 (ring tones are muted). To activate ring tones for the very first time, first enter the
write command and simply change the volume. After applying a firmware update the volume and type
selected before the firmware update will be preserved.
• If the is changed while a call is ringing (RING URC) or active, the ME returns OK, but the new melody
does not take effect until after the call has ended.
• Users should be aware that when using this AT command quickly after "^SYSSTART" a "+CME ERROR:
operation temporary not allowed" is received. The audio data may not yet be accessible, resulting in a short
delay (less than 400ms) before the requested AT command response is returned.
TC63i_ATC_V01.100 Page 484 of 547 11/10/08
Confidential / Released