IBM WebSphere V5.0 Security - CGISecurity

Enable SSL on Domino Server
Enable SSL for the Domino server by modifying the Server document stored in
the server’s Notes Name & Address Book.
1. Make sure you have the keyring file, LDAPSSLServer.kyr, and password
stash file, LDAPSSLServer.sth, in the server’s data directory,
c:\lotus\domino\data.
2. Launch Domino Administrator, and make sure that the Use directory on field
points to your Domino Server.
3. Select the Configuration tab.
4. In the left panel, expand the Server section and click Current Server
Document. You will be presented with server document from your server’s
Name and Address Book.
5. Click Edit Server and select the Ports/Internet Ports tab.
6. In the SSL key file name field, type your key ring file name which you have
created previously. In our case, the file name was LDAPSSLServer.kyr
7. Click the Directory tab and modify the following fields:
SSL port number: 636
SSL port status: Enabled
8. Other fields you can leave as default. The following figure presents our server
document from the scenario tested in this book.
470 IBM WebSphere V5.0 Security Handbook