International Catalogue

Injection in solid brick masonry
Chemical fixings
The versatile fixing system for solid brick masonry
French balconies
Satellite dishes
VERSIONS
▪ zinc-plated steel
▪ stainless steel
APPROVALS
ADVANTAGES
▪ The fixing system comprising threaded
rod FIS A or internal threaded anchor
FIS E and one of the injection mortars
FIS V, FIS VS or FIS VW can be
individually selected based on requirements,
thus allowing for a wide range
of applications.
▪ The wide range of approved threaded
rods FIS A from M6 to M16 allows for
various applications.
▪ The internal threaded anchor FIS E
allows for surface flush removal and
reuse of the fixing point, and therefore
offers the best possible flexibility.
BUILDING MATERIALS
Approved for:
▪ Solid sand-lime bricks
▪ Solid brick
Also suitable for:
▪ Solid and lightweight concrete blocks
▪ Solid pumice and other solid building
materials
APPLICATIONS
▪ Gratings
▪ Gates
▪ Handrails
▪ Consoles
▪ Pipelines
▪ Sanitary equipment
▪ Awnings
▪ Canopies
▪ Satellite antennas
▪ Sun protection
FUNCTIONING
▪ The system can be used with any of
the following injection mortars: FIS V,
FIS VS, FIS VW. FIS VT or FIS P can be
used but do not have approvals.
▪ FIS E is suitable for pre-positioned
installation, whilst FIS A is suitable
for pre-positioned and push-through
installation.
▪ The mortar bonds the entire surface of
the anchor with the drill hole wall and
seals the drill hole.
▪ The anchor is set manually, by lightly
rotating it until it reaches the drill hole
base.
▪ In general, it is also possible to use the
FIS H K anchor sleeves in solid brick
masonry, and this provides additional
safety when the base material is
unknown. Technical data see page
114.
FOR USE WITH
106
FIS V mortar FIS VW mortar FIS VS mortar FIS VT mortar FIS P mortar
see page 71 see page 75 see page 79 see page 83 see page 86