marine corps uniform regulations - US

MARINE CORPS UNIFORM REGULATIONS
1. Wash in warm water and mild detergent containing no optical brighteners
or bleach. Tumble dry at low heat (not to exceed 130 o F). Remove immediately
from the dryer and fold flat or place on a rustproof hanger to ensure heat
from the dryer does not set wrinkles. To drip dry, remove from the
washer/water and place on a rustproof hanger. Do not wring or twist.
2. A hand iron set on low heat may be used to individually press areas such
as collar points or pocket flaps to help maintain a neat appearance. Care
should be taken when pressing creases, as the uniform is manufactured with
permanent creases. Improper pressing may result in multiple permanent
creases. No new creases may be created.
3. The use of starch, sizing and any process that involves dry-cleaning or a
steam press will adversely affect the treatments and durability of the
uniform and is not authorized.
10105. ALL-WEATHER COAT/TANKER JACKET. The AWC and tanker jacket should be
dry-cleaned only. A water repellency treatment should be applied after fouror
five-dry cleanings.
10106. BUTTONS AND INSIGNIA
1. Gold buttons are plated to prevent tarnishing and should not be polished
with abrasives or polishing cloths containing chemicals. Clean gold buttons
with a weak solution of household ammonia and water.
2. Gold-plated buttons that have had the plating removed are likely to turn
green due to exposure to moist air. This can be removed by rubbing gently
with acetic acid or any substance containing this acid, such as vinegar,
followed by a thorough washing in fresh water and drying.
3. The gold-filled parts and the sterling silver rhodium-finished parts of
metal insignia are cleaned by washing with soap and water. Avoid using
silver polish or abrasive.
4. Service insignia will not be polished. If the black finish wears off,
replace the insignia or refinish with USMC approved liquid, black protective
coating as sold through the Marine Corps Exchange. Use of paints or other
unapproved coloring agents is prohibited.
10107. FOOTWEAR
10107
1. Maintenance of leather footwear is necessary to ensure maximum wear and
to protect the healthy, sanitary condition of the feet. When not in use, the
shape of the shoes should be maintained using shoe trees. Foot powder should
be liberally sprinkled inside the shoe to absorb moisture. Constant
inspection is necessary to ensure prompt repair to avoid breakdown of the
upper leather.
2. Shoes should be kept clean as sand, dirt, grit, etc., have a
deterioration action on shoe threads and shoe leather. Clean leather uppers
periodically with saddle soap, which is a leather preservative. Dubbing
should never be used on footwear as such compounds seal the pores of the
leather and cause excessive perspiration.
10-5